FAQ

1.  What types of warranties are available?

Two kinds: Labor and material or material only. Labor and material warranty coverage is what you should look for. Labor and material warranties will cover the full replacement of the faulty material—at no cost to you. A material only warranty covers just that, materials, and they’re the least amount of the costs involved.

2.  Should I be concerned with granules in the gutter?

Asphalt shingles are covered with ceramic granules to reflect water and light to protect the underlying material, and ultimately your roof. Your shingles experience erosion from water, UV light and heat. UV light and heat dries the shingles out; water wears away at the granules, some of which have been loosened by heat and light. Unfortunately, the more granules lost, the faster your roof will deteriorate.

3.  Do I need a new roof?

There are many indicators that suggest you may need a new roof. A persistent leak, unexplained mold inside your home or business, curling shingles, ceramic chips in the gutter and near the drainage pipe on the ground and flashing pulling away from the structure.

4. Should I be concerned about curling shingles?

Curling shingles are an indication that the oils are starting to evaporate and the shingle is shrinking exposing the plywood underneath. Water can then deteriorate the wood decking allowing water to enter your home or business.

5.  Can I place a new roof over my old one?

Installing a new roof on top of the old one isn’t recommended. You may save money in the short run on the cost for removing the old roof, but it will cost you more in the long run because not only will the life expectancy of your new roof be greatly reduced, you’ll spend more on energy costs. As a matter of fact, the life expectancy of your roof can be reduced by half and in most cases your warranties

Here’s why. The second roof layer causes your roof to lose air flow which causes the shingles to overheat. This speeds up the rate at which the ceramic chips will flake off and the shingles dry out (See Curling Shingles). This also causes your home to retain a greater amount of heat causing your air conditioning system to work harder.

6.  What Causes Leaks?

99% of all leaks occur at areas of penetration: chimneys, vents, flashing, air conditioning units, etc. Usually this is due to errors in installation. 70% of the time it takes to install your roof should be spent making sure all areas of penetration are installed and water-proofed correctly. We call this Flashing Detail. This is an aspect of the roof installation process that we take very seriously.

© 2018 JAF Roofing